Current Position:Home >>TECHNOLOGY

Notes of iron briquette machine in the production process

Notes of iron briquette machine in the production process

As the iron powder is different to form,so iron powder should select a large iron briquette machine to mold. Bigger the pressure is, the better effect the mold. Large equipment should strictly abide by the operating system to avoid unnecessary losses and troubles. Today,we highlight the notes of iron briquetting machine in the production process.
1, the iron briquetting machine's operating ground
The iron briquetting machine's operating ground is divided into the chassis
ground and the internal electrical ground. The chassis ground is mainly used to prevent the accumulation of static electricity, electrical leakage, and other outdoor ball machine in particular the installation of the external lightning protection measures. In general, outdoor dome housing installed in the pole bracket screw-metal stents, the natural formation of ground protection, without special treatment.
2, the iron briquette machine operation power supply
In order to ensure the iron briquette machine working properly, the power supply
should not be less than the nominal value of the input voltage of the ball machine. When the nominal value of 24VAC, voltage fluctuations should not exceed 25%. The ball machine common voltage is 24VAC. The wiring should be emphasized that the strong, weak separate to avoid the interference of strong electricity to weak. Ball inside the limited space, built-in transformer so that the strength of electric coexistence, thus affecting the weak signal. In addition, the built-in transformer will increase the heat burden, thus increasing the possibility of built-in circuit burned.
3, iron briquette machine operating ring circuit
Even if the equipment is effectively grounded, but the iron briquetting machine
and the central devices in different positions in the zero electric potential existence of differences in the power load is not balanced will continue to cause the ground potential difference.
4, iron briquette machine operating water
For the installation of suspended iron briquette machine and the department of
stent rotary joint gap. In case of rain and snow, water will penetrate along the cracks internal hazard. Therefore, the power of special machinery prompted to install waterproof sealing measures should be taken to put an end to the rain the choice to enter the dome mounting bracket from the helix interface is also important, and recommended the selection of his first wife bracket. Original bracket given full consideration to the water problem, such as tilt design allows the ball machine to spin then the end is slightly higher. Even if the water will only turn the clock back to column stent, without shed ball machines.
5, heat iron briquette machine operating
The heat in the iron briquette machine work must also be considered. Part of the
brand of ball machine on the market outdoor models, and therefore can not be applied directly to the outdoors, must increase with the outdoor shields and other accessories.
These are just iron pressure the briquetting machine considerations in the
production process, the specific method of operation will vary, according to different methods of machine models. In actual operation, the user can be based on the experience accumulated in the actual production to develop their own method of operation.

Note: If you want to know more about our products , To send questions and get more infomation.

Name: *
E-mail:*
Tel:
Country:
Message:*